going into it I was thinking it would not be fun and as I went along it was fun it was a lot of work and I will prolly never use it but I learned a lot.
step 1 create a circle with the detentions you want I did 8 in. step 2 add 2 rectangles on the side connected to the circle. step 3create the flinger hole that is big enough for you and extrude it. step 4create the path for the ball make sure it is 0.313in and extrude it.
in the end it was fun and I learned how to use fusion and it was overall a good project.
first we have to upload it into the fusion 360 then after that we have to set the measurements and where it will cut out. after that we need to select the fat end mill and the size of your drill bit mine was a 0.25 diameter and a 2 inch length and select the bottom of the shafts and watch it to see if it done it correct then save and set it up on the router.
next we have to engrave the names so set up the color to thr rgb and type your name in then engrave it.
in summery of this project it was long and stressful but i am glad i did it because i will use what i learned from this on my final.